Home-Products-Electronic instruments-Delays, Gates and Delay Generators, Logic Blocks and Linear Gates-425A nanosecond delayer

425A nanosecond delayer

Product model:

Brief description:Aligns fast timing channels containing conformance circuits or TACs 50 calibrated delay cable for linear or logic signals 2ns to 65ns delay in 1ns steps ORTEC Model 425A nanosecond delay provides calibrated delays from 0 to 63ns in 1ns steps for any type of signal

Manufacturer strength
Manufacturer Strength
Valid warranty
Valid Warranty
Quality assurance
Quality Assurance

Product consultation

Contact

Products

PRODUCT CATEGORY

Detailed introduction

Align fast timing lanes containing compliance circuits or TACs
50Ω calibrated delay cable for linear or logic signals
2 ns to 65 ns delay in 1 ns steps

The ORTEC Model 425A Nanosecond Delay provides calibrated delays from 0 to 63 ns in 1 ns steps for any type of signal.

information +
- 425A Brochure
- 425A Brochure (A4)
- 425A Manual
More information +

Longer delay times can be obtained by cascading multiple Model 425A's. These delays are accomplished via RG-58A/U coaxial cables interconnected by stripline sections. No power source is required to operate the instrument.

Type 425A has many uses. For example, it can be used to align fast timing channels to operate coincidence circuits or time pulse height converters. Additionally, due to the high accuracy of the delay, it can be used to calibrate the device.

The 425A has an input and output impedance of 50 Ω, making it compatible with associated signal sources and loads found in other NIM standard modular nuclear instruments.

Specifications +

Performance

Delay accuracy	For each delay section used, ±100 psor ±1％。
Minimum delay (all switching outputs)	2.0 ns。
Impedance mismatch reflection	Switching from any delay ≤±2％。

control

Six slide switches, each with an output and input position, allowing the total delay time to be selected in any combination;
The switch has1、2、4、8、16and32 ns。

Input

BNCConnector accepts signals of either polarity, ±600 V;The impedance is50Ω。

Output

BNCThe connector provides the input signal, and the delay time is set toInswitch selection; the impedance is50 Ω。

electrical and mechanical

Required power supply	None.
weight	Net weight 1.0Kilogram (2.2pounds). Shipping weight1.4Kilogram (3.0pounds).
Size	NIMStandard single width module,3.43 x 22.13cm (1.35 x 8.714inches), consistent withDOE/ER-0457Trequirements.

Ordering information +

Model

Description

425A

nanosecond delay

Product consultation

Previous article:426 linear door
Next article:418A universal compliance

425A nanosecond delayer

425A nanosecond delayer

information +

More information +

Specifications +

Ordering information +

Message box